Expert advice on television repair in Nairobi — screen fixes, motherboard guides, DIY tips and industry news from our certified technicians.
A display that shows two overlapping versions of the same content — one clear and one offset — is experiencing a fault that goes beyond cosmetic annoyance. It often points to a specific fa…
The source COF is one of the most critical components in any LCD display. It carries column driver signals from the driver IC to the pixel matrix, and when it fails, the result is vertical lines or co…
Every LCD and OLED display depends on driver integrated circuits to send signals to its pixels. These ICs are bonded directly to the display panel, and when that bond fails, the display suffers. A dri…
The glass substrate of an LCD panel is not just a structural component — it is the surface to which critical electronic connections are made. When these connections between the glass and its dri…
The edges of an LCD or OLED panel are among its most vulnerable areas. It is here that the driver circuits bond to the glass, where flex cables connect, and where physical stress during handling often…
Row driver failures in LCD panels produce horizontal lines — a fault that is directly traceable to the gate COF connections. Replacing a failed gate COF is a specialised repair that requires bot…
Smart TVs integrate complex software with sophisticated display hardware. When the screen develops faults, the entire viewing and interactive experience is compromised. A smart TV screen repair servic…
Even a perfectly bonded COF will fail to restore a display correctly if it is not aligned with precision. Alignment determines which conductors on the COF make contact with which bonding pads on the p…
Removing old ACF residue from a display panel bonding area is one of the most delicate steps in any display repair or rework process. Done correctly, it prepares the surface for a reliable new bond. D…
A display repair is only as good as the surface it is performed on. Contamination on the panel bonding area is one of the leading causes of bond failure — both in original manufacturing and in r…
